Windows 2000/XP Ethernet Setup - Residential Life & Housing

Windows 2000/XP Ethernet Setup

These instructions are for our residents to use to set up their computers for use on the Ethernet network in the Residence Halls. These instructions are based on a Windows XP computer. Normally, the 2000/XP versions of the Windows operating systems will automatically configure correctly.

If necessary, install your network card and software as directed by your card's instructions. Make sure that the correct drivers are installed for your network card (usually on a single disk/CD included with your network card). Connect the Ethernet cable from your card to the wall jack.

If your card's instructions are not successful in setting up the network, follow the instructions below.

Check your Networking Settings.

Go to your Start menu, select Settings, then Control Panel, then double-click on Internet Options.

Click on the Connections tab

Make sure that the Never dial a connection option is selected.
Click on the LAN Settings radio button.

Your settings should match the picture above.
Click OK twice and close the Control Panel

Check your TCP/IP Settings

Click on your , click on Network Connections, and double-click on your Local Area Connection,

Note: If you click on the Support Tab, and then the Details button, your MAC or Physical address will be listed along with other useful information.

and click on Properties

Double-click on Internet Protocol (TCP/IP)

Your settings should match the picture above. No further setup is required.
Close all open windows by clicking OK, and close the Control Panel.

Restart your computer and test your connection by opening up your web browser.